Dinstar DWG2000F Instrukcja Użytkownika Pobierz pdf (Strona 50)

DWG2000-16G User Manual

_______________________________________________________________________________

Dinstar Technologies Co., Ltd.

4.12.3 Port Configuration

Figure 4-12-3 Port Configuration

Table 4-12-3 Description of Port Configuration

Port Configuration

Used to configure ports’ gain, Auto-Dial, etc.

ALL ports register

used same user ID

The default is not. If set to "yes" ,all the port will use user ID

SIP User ID

It is the account used for registration, equipment port's unique identifier

Authenticate ID

Used for authenticate

Password

Its register Password

Tx Gain

Its DSP’s Tx Gain. Adjusting it will effect volume on GSM side.

Rx Gain

Its DSP’s Tx Gain. Adjusting it will effect volume on IP side.

To VoIP Hotline

When PSTN part client calls to this port, gateway will auto forward to

the hotline User ID. Leave it blank if you don’t need this function.

*Note: Please config Tel->IP Operation if you need this function.

To PSTN Hotline

When VoIP part client calls to this port, Gateway will auto forward to the

number to PSTN part. Leave it blank if you don’t need this function.

*Note: Please config IP->Tel Operation if you need this function.

Auto-Dial Delay Time

The auto-dial delay time of hotline , the range is 0-10 seconds

VoIPon www.voipon.co.uk [email protected] Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 59 60

Brak uwag

Dinstar DWG2000F Instrukcja Użytkownika Strona 50